Large Round Mould and Puck for 2 TON Jack Puck
Jack Pucks are revolutionary presses created to transform plant extracts into a compact paste and to remove excess water.
Equipped with a 2-ton or 8-ton load capacity hydraulic jack, Jack Pucks are light & compact, easy to carry presses.
The Round 2 Ton Small/Large & 2 Ton Sqaure Press, Mould & Puck can be used with the following Jack Puck models:
- Round 2 Ton Small - JP2TSR
- Round 2 Ton Large - JP2TLR
- Square 2 Ton - JP2TSQ
Both 8 Ton Press, Moulds & Pucks can only be used with their respective presses
- Round 8 Ton - JP8TR
- Sqaure 8 Ton - JP8TSQ
Instructions
- Fix the press to a table with the two 'C' clamps supplied
- Put the extracts in the mould.
- Put on the cover and tighten it up with the wing nuts.
- Tighten the release valve with the handle (clockwise).
- Compress the extracts with an up-and-down movement of the handle.
- Loosen the release valve using the handle (counterclockwise).
- Remove the cover by removing the wing nuts first.
- Put back on the wing nuts without installing the cover.
- Tight the release valve with the handle (clockwise).
- Remove the compressed extracts from the mould using an up-and-down movement with the handle.
- Loosen the release valve using the handle (counterclockwise).
- Bring down the mould's base using your fingers.
Warning
- Do not use the jack for any other uses than this press.
- Never use a long handle than the one supplied with the press.
- Never turn the release valve more than one full turn. Do not unscrew release valve completely.
- Never heat the mold, the moulds base or the cover over 200F.
- Use the press on hard, levelled and solid surfaces only.
- Keep oil at the correct level at all times.